12V Intelligent PWM Solar Charge Controller 10A

Professional Manufacturer! 24V/30A PWM Solar Controller

Synopsis of this PWM Controller:

The controller is designed for solar power supply system, solar DC street lamp system, And use the intelligent controller of special computer chips. Use a key type light touch switch, complete all operation and Settings.

With short circuit, overload, unique counter-attack joint protection, full of, put automatic shutoff, restores and so on the whole function protective measures, the detailed charging indicator, battery state, load and all kinds of fault indicator.






The main features:

1, Using MCU and special software, based on the special software of the expert control system, realizes the intelligent optimization SOC control.

2, The temperature compensation adopt external temperature sensor, the control accuracy is higher than the internal temperature sensor.

3, Have the overcharge, discharge, electronic short-circuit, overload protection, unique counter-attack joint protection automatic control; Above the protection are not causing damage to any component, and don't burn the fuse.

4, Adopt the tandem PWM for charging main circuit, make the charging loop voltage is reduce nearly half than use the diode charging circuit. The charging efficiency is higher 3%~6% than the non-PWM, increased the power of time. Enhance the charge of over-discharge recovery, normal direct charge, the float-charge automatically controlled way can make the system has a longer use life.

5, The intuitive LED iuminotron indicates the current battery status, allow users to understand the situation of use.

6, The all control adopt the technical grade chip, can run freely in cold, high temperature, damp environment. At the same time use the crystal oscillator timing control, precise timing control.

7, Using the digital LED display and Settings, a key type operation can complete all Settings, use is very convenient for intuitive.





Installation and use:

1. Controller should be fixed to firm. Dimensions: 150 X 140 (mm)Mounting hole dimensions: 140 X 110 (mm)

2. Prepare for the conductor: Suggest using stranded copper core insulation wire. Firstly confirm the wire length, ensure the case of the installation position, as far as possible to reduce the length of ligature, in order to reduce electric loss. According to induction current density of not more than 5A/mm2 to choose copper conductor sectional area. Put one side of the lug of the controller stripped insulation of 10 mm.

3. To connect the terminal on the battery of the controller, then put the other end of the head connect to the battery. Pay attention to +, - pole, don't reverse connection. If the connection is correct, lamp (2) should be on, can check by press button. Otherwise, shall be checked if the connection is correct. In case of reverse connection, would not burn fuse and damage any component of controller. Fuse only as a protection for the controller itself when the internal circuit damage and short circuit...

4. Connect battery conductor, to connect the terminal of the battery of the controller, then connect the other terminal to the battery. Note the +, - pole, don't reverse connection, if there is sunshine, charging indicator should be on, Otherwise, shall be checked if the connection is correct.

5, Connect the load, put the wired of the load to the output of load of the controller, Note the +, - pole, don't reverse connection, so as not to burn out appliances. 
 Technical indexes